A one day combi swap in Pencoed, hour by hour
Updated 1 October 2026 · 2 minute read
£1,900 from, fully fitted with VAT in Hendre
Get my fixed priceSwapping an old combi for a new one in the same spot is the most common install we do around Pencoed, and it is usually done in a single day. Here is how that day runs, so nothing comes as a surprise.
First thing: arrival and protection
Being based in Pencoed, we are with you early. Dust sheets go down from the door to the boiler, and we check the gas, water and electrics are where the photos showed them.
Morning: old boiler out
- Gas, water and power to the boiler isolated
- The system drained down
- The old boiler and its flue taken off the wall
Your hot water and heating are off from here until the evening, so it is worth showering the night before.
Late morning: flush and prepare
With the old boiler off, the system is flushed to shift the debris that has built up in the pipes and radiators. Then the wall is prepared, the new flue position set and the pipework adapted to the new boiler’s connections.
Afternoon: new boiler on
- New boiler hung and the flue fitted
- The magnetic filter fitted on the return pipe
- Gas, water and condensate connected
- Your controls wired in
Late afternoon: commissioning
The system is filled, bled and pressure checked. The boiler is commissioned, the flue gases are tested, and every radiator is checked to make sure it heats.
Evening: heating back on
Before we leave you get a walk through of the new boiler and controls, your Gas Safe certificate is issued, and the manufacturer warranty is registered. The old boiler leaves with us.
When it takes longer
A swap becomes a two or three day job when the boiler is being moved, when a cylinder and loft tanks are coming out, or when a back boiler is being replaced. All of that is priced and explained before you book.
Around Hendre and the rest of Pencoed, most swaps are like for like. Get my fixed price.